Hurco TM-8 CNC Turning Center with Touchscreen WinMax Control, Tailstock w Hydraulic Quill , Automatic Tool Setter, Chip Conveyor, Coolant System- LIKE NEW- ONLY 350 HOURS
Control: WinMax CNC Control
Max Swing Over Bed: 21.6"
Max Swng Over Saddle: 12.6"
Max Turning Diameter: 12"
Max Turning Length: 19"
Spindle Speeds: 4,800 RPM
Spindle Drive: 20 HP
Spindle Nose: A2-6
Max Bar Capacity: 2"
Turret Capacity: 10
Turret Index Time: .5 Seconds
Turret Travels (X,Z): 8" X 20"
Rapid Traverse Rate (X/Z): 750 IPM X / 945 Z IPM
Tailstock?: YES
Chuck: 8" 3-Jaw Chuck
Distance Between Centers: 23"
A.C. Spindle Motor: 15 HP
Spindle Bore Diameter: 2.44"
WinMax CNC Control with Touchscreen and Keyboard, 10-Station Turret, (5) Turret Boring Holders w Assorted Boring Sleeves, (5) Turning Tool Clamps, Tailstock w Hydraulic Quill & Remote Foot, Automatic Tool Setter, Chip Conveyor, Standard Coolant System, Rigid Tap, 3D Graphics, 3J Collet Nose, Assorted Collets, Hardinge S30 Master Collet with Assorted Collet Pads, 8" 3 Jaw Chuck, Remote Foot for Chuck and Collet Closer , USB and Ethernet Ports, Recovery USB Memory Stick and Cabinet Keys.
WinMax CNC Control with Touchscreen and Keyboard, 10-Station Turret, (5) Turret Boring Holders w Assorted Boring Sleeves, (5) Turning Tool Clamps, Tailstock w Hydraulic Quill & Remote Foot, Automatic Tool Setter, Chip Conveyor, Standard Coolant System, Rigid Tap, 3D Graphics, 3J Collet Nose, Assorted Collets, Hardinge S30 Master Collet with Assorted Collet Pads, 8" 3 Jaw Chuck, Remote Foot for Chuck and Collet Closer , USB and Ethernet Ports, Recovery USB Memory Stick and Cabinet Keys.
230 Volt, 3 Phase